Deep groove ball bearingsIt is the most commonly used rolling bearing. Its structure is simple and easy to use. Mainly used to bear radial load, but when increasing the bearing radial clearance, has a certain angular contact ball bearing performance, can bear the diameter, axial combined load. In the high speed and should not use thrust ball bearing, can also be used to bear pure axial light load. Compared with other types of bearings of the same size, such bearings have a small coefficient of friction, high limit speed. But not impact resistance, not suitable for heavy load.
Feijie produces all kinds of metric and imperial special non-standard deep groove ball bearings (inner diameter φ3~φ100) in Gr15 bearing steel and stainless steel.
Bearings with sealing rings or dust caps
With non-contact rubber seal
With contact rubber seal
Outer ring with stop groove
Outer ring with stop groove and stop ring
Low coefficient of friction
High limiting speed
Low vibration noise
High reliability of use
Electric motors, agricultural machinery, offices, household appliances, power tools, vehicles, gardens, fitness and medical care and a wide range of other areas
1Keeping the bearings and their surroundings clean, even if the smiling dust invisible to the naked eye gets into the bearings, can increase the wear, vibration and noise of the bearings.
2Use the installation carefully, do not allow strong stamping, do not allow direct hammering of the bearing, do not allow the transfer of pressure through the rolling body.
3Use suitable and accurate installation tools, use special tools where possible and strongly avoid the use of cloth and short fibres and the like.
4To prevent rusting of bearings, when picking up bearings directly by hand, fully wash away the sweat on your hands and coat them with high quality mineral oil before operating them, paying particular attention to rust prevention in the rainy season and summer.